kids encyclopedia robot

Admiralty scaffolding facts for kids

Kids Encyclopedia Facts
Admiralty scaffolding drawing
A drawing of Admiralty scaffolding from 1940
Admiralty scaffolding test section
A section of Admiralty scaffolding prepared for testing
Antitank2
Extant remains at Salthouse, North Norfolk, England.
WW2 exposed defunct sea defences
Exposed extant remains at Weybourne camp, North Norfolk, after the storm of October 2002

Admiralty scaffolding, also known as Obstacle Z.1 or sometimes simply given as beach scaffolding or anti-tank scaffolding, was a British design of anti-tank and anti-boat obstacle made of tubular steel. It was widely deployed on beaches of southern England, eastern England and South West England during the invasion crisis of 1940-1941. Scaffolding was also used, though more sparingly, inland.

Design and use

Of a number of similar designs, by far the most common was designated obstacle Z.1. This design comprised upright tubes 9 feet (2.7 m) high and 4 feet 10 inches (1.5 m) apart, these were connected by up to four horizontal tubes. Each upright was braced by a pair of diagonal tubes, at about 45°, to the rear. 20-foot (6 m) wide sections were assembled then carried to the sea to be placed in position at the half tide mark as an obstacle to boats.

However, trials found that a 250-ton barge at 5+12 knots (6.3 mph; 10.2 km/h) or an 80-ton trawler at 7+12 knots (8.6 mph; 13.9 km/h) would pass through the obstacle as if it were not there and a trawler easily pulled out one bay with an attached wire rope. Tests in October 1940 confirmed that tanks could only break through with difficulty, as a result Z.1 was adopted as an anti-tank barrier for beaches thought suitable for landing tanks. As an anti-tank barrier it was placed at or just above the high water point where it would be difficult for tanks to get enough momentum to break through the barrier. In some places, two sets of scaffolding were set up, one in the water against boats and one at high water against tanks.

The problem of securing the barriers on sand was overcome by the development of the "sword picket" by Stewarts & Lloyds – this device was later known at the Admiralty as the "Wallace Sword".

Barriers varying in length from a couple of hundred feet to three miles were constructed consuming 50% of Britain's production of scaffolding steel at an estimated cost of £6,600 per mile (equivalent to £260,000 today ). Despite this, many miles of Admiralty scaffolding were erected using more than 15,000 miles (24,000 km) of scaffolding tube.

After the war, the scaffolding got in the way of swimmers, subsequently it was removed for scrap and remaining traces are very rare, but occasionally revealed by storms.

See also

kids search engine
Admiralty scaffolding Facts for Kids. Kiddle Encyclopedia.